x7722271404 / x772000164 TC-210 TILLER / CULTIVATOR Operator’s Manual Burn Hazard The muffler or catalytic muffler and surrounding cover may become extremely hot. Always keep clear of exhaust and muffler area, otherwise serious personal injury may occur. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
TABLE OF CONTENTS TC-210 TABLE OF CONTENTS Table of Contents .............................................................................................................................. 2 Introduction ........................................................................................................................................ 3 The Operator’s Manual ................................................................................................................ 3 Servicing Information .........
TC-210 INTRODUCTION INTRODUCTION Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job dependability. Read and understand this manual. You will find it easy to use and full of helpful operating tips and SAFETY messages. The Operator’s Manual Keep it in a safe place for future reference. Contains specifications and information for safety, operation, maintenance, storage and assembly specific to this product.
SAFETY TC-210 Safety Videos are available from your Echo dealer. A $5.00 shipping charge will be required for each video. SAFETY Manual Safety Symbols and Important Information Throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages preceded by symbols or key words. The following is an explanation of those symbols and key words and what they mean to you.
TC-210 SAFETY International Symbols Symbol Description Symbol Description Symbol Description Symbol Description Read and understand owners manual. Fuel and oil mixture Carburetor Adjustment - Low speed mixture Carburetor Adjustment - High speed mixture Wear eye, ear and head protection Finger severing Safety/Alert Carburetor Adjustment - Idle speed Emergency Stop Hot Surface Avoid all power lines. This unit is not insulated against electrical current. Carry unit with carry handle.
SAFETY TC-210 Personal Condition and Safety Equipment Users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit. Physical Condition Your judgment and physical dexterity may not be good: • If you are tired or sick. • If you are taking medication. • If you have taken alcohol or drugs. Operate unit only if you are physically and mentally well.
TC-210 SAFETY • DO NOT WEAR OPEN TOED SHOES. • DO NOT OPERATE UNIT BAREFOOTED. Keep long hair away from engine and air intake. Retain hair with cap or net. Heavy protective clothing can increase operator fatigue, which may lead to heat stroke. Schedule heavy work for early morning or late afternoon hours when temperatures are cooler. The components of this machine generate an electromagnetic field during operation, which may interfere with some pacemakers.
SAFETY TC-210 Repetitive Stress Injuries (RSI) It is believed that overusing the muscles and tendons of the fingers, hands, arms, and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI). An extreme RSI condition is Carpal Tunnel Syndrome (CTS), which could occur when your wrist swells and squeezes a vital nerve that runs through the area.
TC-210 EMISSION CONTROL (EXHAUST & EVAPORATIVE) Avoid Hot Surfaces • Keep exhaust area clear of flammable debris. Avoid contact during and immediately after operation. Equipment Use only ECHO attachments. Serious injury may result from the use of a non-approved attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO.
EMISSION CONTROL (EXHAUST & EVAPORATIVE) TC-210 An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by engine FAMILY).
TC-210 DESCRIPTION DESCRIPTION Locate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and follow the instructions on it. If a decal cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information. 8 9 10 1 15 14 11 2 16 12 17 13 3 7 4 5 10 6 Tine Guard Label Hot Label X7504083607 © 9/2014 ECHO Inc.
DESCRIPTION TC-210 1. STOP SWITCH - Toggle Switch mounted on throttle handle. Move switch forward to "RUN" position to run, back to "Stop" position to stop unit. 2. THROTTLE TRIGGER - Spring loaded to return to idle when released. When accelerating, pull trigger gradually for best operating technique. DO NOT hold trigger when starting. 3. SPARK PLUG - Provides spark to ignite fuel mixture. 4.
TC-210 CONTENTS CONTENTS The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, shield installation and other assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.
ASSEMBLY TC-210 ASSEMBLY 1. Support powerhead assembly upright on tines. Place top handle assembly to rear. Note: Make sure inside curves at handle ends are facing each other. 2. Loosely assemble lower handles using short 1/4 in. x 3 in. long hex head shoulder bolt (A), eye plates (B), lockwasher (C), and locknut (D) in front handle end mounting hole as shown. A C,D 3. Slide lower handle assembly under power head and throttle linkage/ignition wires, and position in mounting groove. B 4.
TC-210 OPERATION 10. Position top kick stand mounting plate on lower handles, matching curved mounting plate channels to angle of handles. Secure top plate to kick stand mounting plate with (2) 6 x 12 mm bolts, and tighten securely Note: In down position, lower end of kick stand must rest flat against ground. No efectúe nunca tareas de cultivadora con el arrancador de pie en la posición bajada, ya que de lo contrario se pueden producir lesiones graves.
OPERATION TC-210 Two Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FD Standards must be used. Echo brand premium Power Blend X™ Universal 2-Stroke Oil meets these standards. Engine problems due to inadequate lubrication caused by failure to use an ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FD certified oil, such as Echo premium Power Blend X™, will void the two-stroke engine warranty.
TC-210 OPERATION Storage - Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, airtight container. Store in a well-ventilated, unoccupied building, away from sparks and flames. Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added. Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.
OPERATION TC-210 6. Recoil Starter Pull recoil starter handle/rope (D) until engine fires. Note: If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5. D 7. Throttle Trigger After engine warm-up, gradually depress throttle trigger to increase engine RPM to operating speed. Starting Warm Engine The starting procedure is the same as Cold Start except DO NOT close the choke. A 1. Stop Switch Move stop switch button (A) forward away from the STOP position. C 2.
TC-210 OPERATION Stopping Engine 1. Throttle Trigger A Release throttle trigger and allow engine to return to idle before shutting off engine. 2. Stop Switch Move stop switch button (A) backward to STOP position. If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using unit again. Tilling/Cultivating Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas.
OPERATION TC-210 TILLING - Recommended tilling depth is 15-20 cm (6 - 8 inches) Install Tines with individual tines angled forward, toward front of unit. (See Tine Removal/Cleaning/Installation) • Use a forward/backward motion to till soil. Allow tines to dig into soil, then pull unit back to break up and pulverize clumps. Tilling depth is controlled by the number of times the forward/backward motion is used in an area.
TC-210 MAINTENANCE MAINTENANCE Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service. Wear gloves to protect hands from sharp edges and hot surfaces. Your ECHO unit is designed to provide many hours of trouble free service.
MAINTENANCE TC-210 Air Filter Level 1. Parts Required: REPOWERTM AIR & FUEL FILTER KIT. 1. Close choke (Cold Start Position [ ]). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area. 2. Remove air filter cover. Brush dirt from inside cover. 3. Remove air filter and lightly brush debris from filter. Replace filter if it is damaged, fuel soaked, very dirty, or the rubber sealing edges are deformed. 4.
TC-210 MAINTENANCE Spark Plug Level 2. Parts Required: REPOWERTM Tune-Up Kit Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) otherwise severe engine damage may occur. .65 mm (.026 in.) 1. Remove spark plug and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine. 3. Adjust spark plug gap by bending outer electrode. 4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).
MAINTENANCE TC-210 3. Disconnect spark plug lead. 4. Remove cylinder cover. 5. Use brush to remove dirt from the cylinder fins. DO NOT use a metal scraper to remove dirt from the cylinder fins. B A 6. Assemble components in reverse order. Note: When installing the cylinder cover, be certain the muffler gasket tabs are locked into the muffler grill slots and the stop switch lead is seated in the relief notch. Exhaust System Spark Arrestor Screen B Level 2.
TC-210 MAINTENANCE Exhaust Port Cleaning A B Level 2. Parts Required: Heat Shield 1. Remove spark plug lead from spark plug, and remove engine cover. 2. Place piston at top dead center. Remove muffler (A) and heat shield (B). 3. Use a wood or plastic scraping tool to clean deposits from cylinder exhaust port. Never use a metal tool to scrape carbon from the exhaust port. Do not scratch the cylinder or piston when cleaning the exhaust port. Do not allow carbon particles to enter the cylinder. 4.
MAINTENANCE TC-210 Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations. In addition, the carburetor is equipped with HI (A) and LO (B) needle adjustment limiters that prevent settings outside acceptable limits Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations. Carburetor adjustments, other than idle speed, must be performed by an authorized ECHO dealer. 1.
TC-210 MAINTENANCE Gear Housing D 1. Remove tines (See Tine Removal/Cleaning - Installation below). 2. Remove gear case cover (A). Be careful not to tear sealing gasket (C). 3. Support tiller with exposed gear case (D) upward. Add grease until nearly level with top of gear case (D). B C A Do not over fill. Too much grease will cause pressure and possible seal failure. Tine Removal/Cleaning - Installation Note: Always wear gloves to protect hands from sharp blades.
TROUBLESHOOTING TC-210 TROUBLESHOOTING ENGINE PROBLEM TROUBLESHOOTING CHART Problem Check Remedy Fuel strainer clogged Fuel line clogged Carburetor Clean or replace Clean or replace See your Echo dealer No fuel at cylinder Carburetor See your Echo dealer Muffler wet with fuel Fuel Mixture too rich Open choke Clean/replace air filter Adjust carburetor See your Echo dealer No spark Stop switch off Electrical problem Interlock switch Turn switch to ON See your Echo dealer See your Echo dealer S
TC-210 STORAGE STORAGE During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result. Long Term Storage (Over 30 Days) Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following: 1.
SPECIFICATIONS TC-210 SPECIFICATIONS MODEL TC-210 Length 1130 mm (44.48 in.) Width 340 mm (13.36 in.) Height 1010 mm (39.76 in.) Weight (dry) w/tines 9.07 kg (20 lb.) Engine Type Air cooled, two-stroke, single cylinder gasoline engine Bore 32.2 mm (1.27 in.) Stroke 26.0 mm (1.02 in.) Displacement 21.2 cc (1.29 cu. in.
TC-210 WARRANTY STATEMENTS WARRANTY STATEMENTS ECHO LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010 ECHO'S RESPONSIBILITY ECHO Incorporated’s Limited Warranty, provides to the original purchaser that this ECHO product is free from defects in material and workmanship.
WARRANTY STATEMENTS TC-210 PURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIES GD\ UHVLGHQWLDO RU QRQ LQFRPH SURGXFLQJ ZDUUDQW\ GD\ FRPPHUFLDO LQVWLWXWLRQDO DJULFXOWXUDO LQGXVWULDO LQFRPH SURGXFLQJ RU UHQWDO DSSOLFDWLRQ ZDUUDQW\ ATTENTION TWO-STROKE ENGINE POWER PRODUCT OWNERS This ECHO two-stroke engine power product is a quality-engineered unit which has been manufactured to exact tolerances to provide superior performance.
TC-210 PRODUCT REGISTRATION PRODUCT REGISTRATION Thank you for choosing ECHO Power Equipment Please go to http://www.echo-usa.com/Warranty/Register-Your-ECHO to register your new product on-line. It's FAST and EASY! NOTE: your information will never be sold or misused by ECHO, Inc. Registering your purchase enables us to contact you in the unlikely event of a service update or product recall, and verifies your ownership for warranty consideration.
NOTES TC-210 NOTES 34 X7504083607 © 9/2014 ECHO Inc.
TC-210 X7504083607 © 9/2014 ECHO Inc.
ECHO, INCORPORATED 36 400 Oakwood Road Lake Zurich, IL 60047 www.echo-usa.
