Instructions for Use

19
Installation Guide
19
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
18
Installation Guide
18
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Once installed, the factory screen will automatically switch to the reverse camera whenever the vehicle is
placed in reverse gear. The reverse camera can also be manually activated at anytime by pressing and holding
the center button on the back left side of the steering wheel for at least 4 seconds. If the vehicle does not have
controls on the back of the steering wheel, the supplied on-demand activation toggle switch can be used to
force the reverse camera on if desired.
Step 8A
For vehicles with steering wheel controls, or if on-demand
camera activation is not desired, set the toggle switch to
the Center Position (Off), bundle and zip tie the switch wires
to the main harness.
Step 8B
For on-demand camera activation using the toggle switch,
route and install the toggle switch in the desired location.
Set switch to Center Position (Off) until the BCI interface is
programmed to the vehicle.
Wire Connections (continued)
The switch hole size is 1/4” and the nut is 8mm.
NOTE
Nothing will be plugged into the other end of the
BCI-CH21-AUX harness.
NOTE
Step 9
Locate the gray 22-pin vehicle radio plug that was
unplugged from the radio during disassembly. Connect
it to the matching female plug on the BCI-CH21-HAR.
Step 10
Plug the other end of the BCI-CH21-HAR into the back of
the radio.
Step 11
Plug the matching connector on the BCI-CH21-AUX
harness into the other 22-pin port on the back of the radio.
OR