Instructions for Use

5
Installation Guide
5
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
4
Installation Guide
4
tel - 1-800-477-2267
email - [e-mail]
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Step 1
Remove the spare tire off of the tire carrier.
Disassembly
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Recommended Tools
Installation Notes
Step 2
Remove the trim panel on the inside of the tailgate by pulling
it away from the tailgate along the bottom of the panel
from one side to the other. Then swing the panel upward to
disengage the upper tabs. A plastic trim tool may be needed
for this step.
Once a part is removed, place it in a safe area to avoid
damage.
NOTE
Before proceeding with disassembly, it’s
recommended to confirm wheel design will work
with the camera mount by temporarily installing
the camera mount (page 12) and reinstalling the
spare tire. Confirm a usable opening in the wheel is
located at center. This may require removing and
rotating the wheel until a usable opening is located.
NOTE
Lug Wrench
Plastic Trim Tool
7mm Socket
8mm Socket
10mm Socket
Ratchet
Socket Extension
Torx T-30
Diagonal Cutters
Wire Crimpers
Electrical Tape
Wire Feeder
Drill / Drill Bits
Hammer
11/16” (17mm) Deep Socket
Small Pick Tool
Read this installation guide thoroughly before disassembling vehicle or making wire connections.
Installation of this product requires technical skill, experience, and specialized tools. If unsure,
it is recommended to have it professionally installed by an authorized EchoMaster Dealer.
This guide covers basic installation of the BCI-CH21 for rear camera only. If adding front or
side cameras, navigation unlock or any other advanced features of the BCI-CH21, consult the
BCI-CH21 Installation Manual.
Questions?
Reach out to our Technical Support Team:
Phone: [phone]
Email: [e-mail]
Chat: EchoMaster.com
A video installation guide is available at:
https://stingerelectronics.com/installvideos