Instructions for Use

9
Installation Guide
9
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
8
Installation Guide
8
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Step 10
Remove the glove box compartment by using the handle to
open it and then squeezing the sides to release the retaining
posts. Once retaining post are clear of the sub dash, tilt
down and pull towards the rear of the vehicle to remove.
Step 13
Remove the two 7mm screws from the bottom edge of the radio/
instrument cluster trim panel on either side of the steering column.
Step 14
Using a plastic trim tool, gently pry to release and remove the
power window switches or storage pocket below radio. Disconnect
the connector on the back of the switch assembly.
Step 12
Remove the knee bolster panel below the steering column using a
plastic trim tool to release the upper left and right clips and swing
the panel downward to disengage lower locking tabs.
Step 11
Using a plastic trim tool remove the passenger side dash
trim panel.
Disassembly (continued)
Step 9
Grab the passenger side door sill at the front most edge and
pull it towards the middle of the vehicle to release the two
fasteners. Remove the sill panel and set aside.