Instructions for Use

13
Installation Guide
13
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
12
Installation Guide
12
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Step 1
Slide the camera mount onto the top wheel studs. Using
11/16” (17mm) deep socket and a hammer, install the push
nut onto one of the wheels studs.
Step 2
Remove the rubber grommet on the right side of the tire
carrier.
Step 3
Using diagonal cutters or similar, cut a slit in the grommet
to allow the camera cable to pass through.
Step 1
Route the camera cable through the factory opening in the
top of carrier and through the opening towards the
passenger side.
Step 2
Feed the cable through the rubber grommet (1) and then
into the tailgate through the hole in the outer panel (2).
Step 3
Feed the cable inside the tailgate up to the access hole on
the inside door panel. A wire fishing tool may be needed.
Mounting the Camera Routing the Camera Cable
2
INSIDE PANEL
1