Instructions for Use

15
Installation Guide
15
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
14
Installation Guide
14
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Step 7
Using a wire fishing tool route the cable through the hole in
the passenger side of the dash just above the speaker.
Step 8
Route the cable across the top of the glove box to the radio
opening. Secure with zip ties.
Step 9
Route the camera cable through the metal radio support
bracket.
Step 4
Unclip and untape the tailgate wire harness that runs into
the cargo area. Using a wire feeder, route the camera cable
through the fabric wire loom.
Step 5
Connect the Camera Extension Cable to the Camera Cable
by lining up the arrows on the two 4-pin ends and pushing
together.
Route the camera extension cable towards the front of the
vehicle following the factory wire harness. Secure with zip
ties.
Step 6
Continue following the factory wire harness forward, across
the door sill(s), up to the glove box area. Secure with zip
ties.
Routing the Camera Cable (continued)
The zip tie clips securing the wire harness can be removed
by using a small pick tool to release the zip tie locking tab.
Or the zip tie can be cut and then a new zip tie ran through
the base of the clips.
NOTE