Instructions for Use

17
Installation Guide
17
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
16
Installation Guide
16
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
EM-BUC-KIT-JW
Jeep Wrangler JK Backup Camera
Step 1
Connect the Camera RCA/Power Lead Adapter to the end
of the Camera Extension Cable.
Step 4
On the BC1-CH21-AUX harness (white plugs), disconnect
the two yellow RCA’s that are marked CAMERA.
Step 2
Crimp the red male bullet connector to the Red camera
power wire. Crimp the blue female spade connector to the
Black camera ground wire.
Step 5
Connect the male yellow RCA on the Camera RCA/Power
Lead Adapter to the female RCA marked CAMERA on the
BCI-CH21-AUX harness.
Step 3
Connect the Programmable Output 1 red wire on the BCI-
CH21-HAR (gray plugs) to the red camera power wire.
Step 6
OPTIONAL: The BCI-CH21 has a status LED that indicates
when a camera is active. If this is desired, mount the LED
and connect the Red and Black wires marked LED ONLY to
the LED. If the LED is not used, bundle and zip tie the LED
wires to the main harness.
Wire Connections