User Manual

Installation Guide
5
email - [e-mail]
tel - 800-477-2267
4
Installation Guide
email - [e-mail]
tel - 800-477-2267
Installing the Camera - continued Setting Up the Monitor
Step 5
Insert each of the wire ends from the
camera cable into the male T-Taps.
Crimp the T-Tap onto the wire to secure
its position.
Red Wire >> 12V / power
(when vehicle is shifted to reverse gear)
Black Wire >> Ground.
Step 1
Slide the arm onto the back of the
monitor. Press on to the dash or
windshield.
Push lever towards the
base to secure in place.
Step 3
Connect the USB cable to the USB
power adapter and insert it into the
vehicle’s lighter / 12v socket.
Step 2
Fine tune the monitor’s position and
make sure to tighten the knobs on
the bracket when nished.
Step 6
Locate your reverse light wires. Position
the female T-Taps onto each wire. Close
the T-Tap onto the wire of the reverse light.
You can use regular pliers for this.
Make sure its connection is secure.
Step 7
A voltmeter may be necessary to
determine polarity, + and -.
Connect the T-Taps together.
MRC-WLP43
Wireless Backup Camera
& Color Monitor Kit
MRC-WLP43
Wireless Backup Camera
& Color Monitor Kit
to order additional car chargers and
power cables, please visit iSimple.com
Step 5
Step 5
male T-Taps
female T-Taps
Step 6
Step 6Step 6
Step 7
Step 7
Step 1
Step 1
Step 1
Step 2
Step 3
USB Power
Adaptor