Installation Guide

5
Installation Guide
4
Step 1
Remove the 2 screws that secure the third
brake light to the vehicle.
Step 2
Remove the third brake light from the
vehicle and disconnect connector on the
back. Replace the factory third brake
with the PCAM-CHMSL2-DR08. Connect
the new third brake light to the factory
connector.
PCAM-CHMSL2-DR08
Replacement Third Brake Light Camera
Step 3
Using a long zip tie or sh tape with the
camera cable attached to it, feed the
camera cable from the third brake light
opening into the vehicle and towards the
b / c pillar to the right or the left. (The
weather seal may need to be removed to
gain access to the sh tool used to run
the cable.)
Installing CHMSL Camera