PCAM-JP3 Installation Guide Spare Tire Mount Camera for 2007-2018 Jeep Wrangler JK
Installation Guide 2 Right Angle Bracket 1. Using two M3 x .50 screws and lock washers, attach the camera to the Camera Mounting Plate. 1 2. Using a M6 x 1 screw and lock washer, attach the Camera Mounting Plate to the Right Angle Bracket as shown. Camera Mounting Plate 1 Assembly 3A. For most applications with stock/standard wheels, attach the camera bracket assembly to the Wheel Bracket using a M6 x 1 screw and lock washer.
PCAM-JP3 Spare Tire Mount Camera Riser Plate 3B. For larger wheels, attach the Riser Plate to the Wheel Bracket and attach the camera assembly to the Riser plate using M6 x 1 screws and lock washers. 3B 4. Place the completed assembly on the tire carrier wheel studs and install the supplied push nut retainers on the wheel studs. Replace the spare tire. Position the camera as close to center as possible.
Wiring Diagram Video Signal Switched +12V (Red) Ground (Black) Parking Lines (Green) On - Joined (Default) Off - Cut Contact Technical Support: email - support@aampglobal.com tel - 1-800-477-2267 web - EchoMaster.com EchoMaster is a Power Brand of AAMP Global. 15500 Lightwave Drive, Suite 202, Clearwater, Florida 33760 IG-PCAM-JP3 REV.
