User's Manual

A. Receiver and TV set-up
Check the Installation
To get the most out of the EchoStar AD-3000IP VIACCESS it should be correctly installed, the dish
should be optimally aligned and the mechanical limit switched on the dish should be set properly.
Press /I on the remote control unit (RCU) or press on the front panel of the EchoStar AD-3000IP
VIACCESS to switch the unit on.
5. Operation and Menu Program
13
The receiver is supplied with factory setting and will start up with the “Language Setting” menu.
After selecting the language settings, the ”LNB Setting” menu will be shown. Please follow the steps outlined
below to properly install the EchoStar AD-3000IP VIACCESS.
You can select the desired language for the OSG (On-
Screen Graphics) display using the , keys when the
“Menu Language” option is selected. Similarly you can
selected a different audio channel when the “Audio
Language” option is selected. This option allows you to
select a different language to listen to if supported.
LNB Setting
Select the LNB type which conforms to your LN
B using the , keys.
Other parameter values should be changed
manually according to your LNB type.
Press the OK key to confirm your selection.
Select the “LNB Setting” menu in the “Installation” m
enu using the , keys.
If you have a Mechanical Polarizer with your LNB, you have to set the “Polarity Control” parameter in this
menu to [Polarotor].
If the Loopthrough option is set to ON, the Loopthrough ports should be set according to the diagrams on
pages 11. If no Loopthrough is used this option should be set to OFF.
LNB Setting
LNB Freq.Low 5150
LNB Freq. High 5150
DiSEqC DiSEqC 1..4
DiSEqC Port 1
Polarity Control 13/18V
LNB Freq. Band Control 0/12V
Ku/C Control Disable
LNB Type Index (1..8)
0/22kHz Control Off
0/12V Control Off
LNB Power On
Loopthrough for Analog On
1
2
4
3
5
6
7
8
9
10
11
× Type 1 Ø
i
Exit
12
Language Setting
Language Setting
Menu Language
Main Audio Language English
× English Ø1
2
2nd Audio Language English
Subtitle Language English
3
4
Exit
i