User's Manual

26
Note 1) You should execute “Auto Search” after editing the satellite or the transponder.
If “Auto Search” is executed after adding the new transponder, all channels of the added
transponder will be searched and stored automatically.
Note 2) You can add or edit totally of 50 satellites. This includes the pre-programmed satellites.
The receiver has the cap ability to store up to 999 transponders and 5000 channels.
CAUTION: By doing an Auto Channel search you will lose all the data
(e.g. FAV, Lock…) which you have edited.
Advanced Installation
Satellite
Longitude 019.2 °E
Digital/Analog Digital
TP/Signal Quality 0
LNB polarization Vertical
Symbol Rate 0
Channel Name ????????
FEC AUTO
Edit/Add SAT or TP
3
2
5
6
7
8
4
1
9
10
11
Video PID 0
PCR PID AUTO
Audio PID 0
× ASTRA1 Ø
Edit/Add SAT or TP
C. Advanced Installation
Auto Scan
Auto Sat
Reset(Factory Default)
Edit/Add SAT or TP
Advanced Installation
Edit LNB Local Freq.2
3
4
5
1
Exit
i
Satellite ASTRA1
Longitude 019.2 °E
Digital/Analog
Channel RTL_2
Frequency 11214.00
Polarity Horizontal
Decoder Level 2
C/Ku Ku
Edit/Add SAT or TP
2
5
6
7
8
4
3
1
9
10
11
Decoder Off
Skew Not set
Low Threshold Off
× Analog Ø
12 Ú More Ú (Audio Setting)
To edit any satellite or transponder, select satellite and transponder to be edited.
You can convert from digital to analog and vice versa, at “Digital/Analog” parameter.
You can change the name of the satellite, transponder, channel name and such.
To change channel name, place highlight bar to “8 Channel Name” and keep pressing
one of either the or keys till it reaches “??? Add ch”.
Then, press the OK key to activate graphic key board and now you can edit the name up to 10-character
length. For some words,, maximum number of the characters is 11. And, mostly 8 characters from
the start shall be shown on the menu when you finish changing name.
You can select the “Advanced Installation” menu
on the “Installation” menu of Main menu by using
the Channel up/down keys (Ù,Ú).