Operation Manual

ManualsBrandsEchostar ManualsDigital decoderdsb 808 2ci

Section 3

Familiarization

User Manual

Page 3 - 2 Digital Satellite Receivers - Fixed

English

1.2. THE RECEIVER REAR PANEL

The rear panel gives you various connections to connect the audio and video equipment as

well as a terrestrial and dish antennas. Depending on the installation setup, you may not use

all connectors, but they are provided for any desired setup in future.

The available connectors on the rear panel are:

1.3. THE RECEIVER SOFTWARE

The use of the receiver is described in the EchoNAV user manual that is also part of the

documentation set.

■ The mains connector, for the connection

to the mains power socket.

■ The LNB IN connector (F-type),

for the connection of a dish to the

receiver, to receive the digital

broadcasts;

■ The SERIAL PORT connector

(sub-D), for the connection to the serial

communication port of a PC;

■ The IF OUT connector (F-type),

for a loop through connection;

■ The VIDEO connector (RCA),

for the connection to the composite

video input of the TV (monitor);

■ The ANT IN connector (IEC),

for the connection of an terrestrial

TV antenna;

■ The S/PDIF connector (RCA),

for the connection of Dolby Digital (AC-3)

compatible audio equipment;

■ The TV OUT connector (IEC),

for the connection to the antenna

connector of a TV or a VCR;

■ The AUDIO L connector (RCA),

for the connection of the left audio input

channel of a stereo set;

■ The VCR connector (SCART), for the

connection of a VCR with the use of a

fully-featured SCART cable;

■ The AUDIO R connector (RCA),

for the connection of the right audio input

channel of a stereo set;

■ The TV connector (SCART),

for the connection of a TV with the use of

a fully-featured SCART cable;