Operation Manual

Section 2 Familiarization EchoStar User Interface
Page 2 - 4 Digital Satellite Receivers - Fixed
© 2003 EchoStar International Corporation
All rights reserved
English
2
DELETE SAT
E
DIT SAT
A
DD TP
E
DIT TP
E
DIT PID
2.1.4. DISH INSTALLATION
■ 1 To select the SAT that you want to delete. Note that all TV and
radio channels are deleted.
■ SAT To show the current satellite you want to change the settings for.
■ LNB To select the LNB that you want to use for the selected SAT.
■ Position
(DiSEqC1.2 only)
Shows the database number of the satellite.
■ Move dish
(DiSEqC1.2 only)
To move the dish and find the defined SAT.
■ Fine tune
(DiSEqC1.2 only)
To move the dish for best signal level and quality.
■ Re-align dish
(GoTo X only)
To compensate for a dish offset caused by ambient conditions.
■ SAT To select the satellite you want to change the settings for.
■ Frequency To set the required frequency (MHz).
■ Symbol rate To set the required symbol rate (MSym/s).
■ LNB To select the LNB that you want to use for the selected SAT.
■ Polarity To select the required polarity (Horizontal/Vertical).
■ 22kHz To select the control signal (Auto, On, Off) for the switch.
■ Channel type To search for All channels, only FTA or only Scrambled
channels.
■ Channel To search for All channels, only TV, only Radio or only Data
channels.
■ Search channels Search channels does a channel search on the defined TP.
■ SAT
(blue key)
To select the satellite you want to change the settings for.
■ Frequency To view the current frequency (MHz).
■ Symbol rate To view the current symbol rate (MSym/s).
■ Polarity To view the current polarity (Horizontal/Vertical).
■ Delete
(yellow key)
To delete the selected transponder.
■ Edit PID
(green key)
To select the Edit PID sub-menu were you can set the required
settings (Frequency, Symbol rate, LNB and PIDs).
■ Confirm
(red key)
To confirm the new settings and return to the Edit TP menu.
■ SAT To select the satellite you want to change settings for.
■ Frequency To set the required frequency (MHz).
■ Symbol rate To set the required symbol rate (MSym/s).
■ LNB To select the LNB that you want to use for the selected SAT.
■ Polarity To select the required polarity (Horizontal/Vertical).
■ Video PID To set the required Video PID.
■ Audio PID To set the required Audio PID.
■ PCR PID To set the required PCR PID.
■ SAT To select the satellite you want to check for the signal strength.
■ TP To select the TP you want to check for the signal strength.
■ View To list the channels that belong to the selected TP.