Operation Manual

Section 2 Familiarization EchoStar User Interface
Page 2 - 6 Digital Satellite Receivers - Fixed
© 2003 EchoStar International Corporation
All rights reserved
English
2
UHF MODULATOR
CHANGE PIN-CODE
2.2.2. CHANNELS
S
ET UP FAVORITES
EDIT CHANNELS
EDIT FAVORITES
2.2.3. MAINTENANCE
C
OLOR SETTINGS
SOFTWARE UPGRADE
■
Installation lock To lock the Installation and User data menu for unauthorized
users. Note that the Installation lock comes on automatically
after you have set a channel lock.
■ Receiver lock To lock the receiver completely for unauthorized users. If you
select On, you only can gain access with the PIN-code after you
have set the receiver to standby.
■ Dolby Digital To tell the receiver that it is connected to a Dolby Digital
amplifier or not. When you have selected On, note that analog
audio is not given to the TV, so no audio is heard. If you want to
listen through the TV audio, select Off.
■ Transparency To set the menu transparency level.
■ Channel To set the TV channel to which the receiver is connected. If the
channel number on the TV and receiver are not the same, you
will have a distorted or no image at all. For more information,
please refer to the user manual of the TV.
■ Video standard1 To set the video format supported by your country and TV.
■ PIN-code
(Current, New, Verify)
To type in the factory default (0000) or your personal PIN-code.
■ Fav 1 (red) To add or delete the highlighted channel for this favorite list.
■ Fav 2 (green) To add or delete the highlighted channel for this favorite list.
■ Fav 3 (yellow) To add or delete the highlighted channel for this favorite list.
■ Fav 4 (blue) To add or delete the highlighted channel for this favorite list.
■ Rename To rename the favorite channel lists.
■ Delete (red) To delete the highlighted channel from the all channels list.
■ Move (green) To move the highlighted channel to another position.
■ Lock (yellow) To lock the highlighted channel (Parental control).
■ Rename (blue) To rename the highlighted channel.
■ Move To move the highlighted channel to another position.
■ Items To select the menu item that you want to give another color.
■ Red To make the item color more or less red.
■ Green To make the item color more or less green.
■ Blue To make the item color more or less blue.
■ Default To change all personal color settings to the pre-defined colors.
■ SAT To select the satellite you want to download from.
■ Freq To set the required frequency you want to download from.
■ SR To set the required symbol rate you want to download from.
■ LNB To select the LNB that you want to use for the selected SAT.
■ Pol To select the required polarity you want to download from.
■ 22kHz To select the control signal (Auto, On, Off) for the switch.
■ PID To set the required PID you want to download from.