Operation Manual

User Manual Familiarization Section 2
S/W Version 1.0 Page 2 - 7
© 2003 EchoStar International Corporation
All rights reserved
English
2
DELETE CHANNELS
FACTORY RESET
FULL RESET
2.2.4. CLOCK
L
OCAL TIME
* Availability depends on the selection as made in for the Clock mode.
■ Conform before
update
To select Yes / No before you actually start the download action.
If you select Yes and the software version is the same as the
current software, you are asked if you want to continue.
If you select No, the download starts automatically and the
software version is written to the receiver memory where it
deletes the current installed version.
■ Start Starts the Software upgrade procedure.
If a new software version is found on the satellite, the receiver
starts to download the new software version in temporary
memory. When the download is complete, the new software
version is written to the receiver memory where it deletes the
previous version. This process can take up to approximately
30 minutes. The Software upgrade is completed when the
receiver restarts and returns with live video.
■ Check OTA (green) To look on the satellite if new software is available for download.
■ Signal indicator To show the signal level and quality of the download signal. If
you have a poor reception due to weather conditions, please try
later.
■ Delete settings To delete all channels from the channel and favorite lists.
Difference with the Full reset is that all installation settings are
kept.
■ Delete settings It is advised to write down the most important settings before
you confirm the Factory reset (e.g. Switch and Port settings,
LNBs, User data, etc.).
The receiver deletes all user defined settings, channels, timers
and (favorite) lists and replace them with the factory defaults
and pre-programmed channel lists.
■ Delete settings To delete all channels from the channel and favorite lists as well
as the installation settings.
The receiver automatically deletes all settings and starts with
the Guided setup.
■ Clock mode To select internal or satellite clock.
■ Time zone* To select the city closest to you.
■ GMT* Shows the time-offset as a result of the time zone selection.
■ Time* To set the current time.
■ Date* To set the current Date.
■ Local time The Local time is shown automatically with the settings made
before and offer you a possibility to check for the correct time.
■ Local date The Local date is shown automatically with the settings made
before and offer you a possibility to check for the correct date.
■ Daylight saving* To set the summer time (if applicable to your region).
NOTE
The time shown in the Local time field offers you a possibility to check for the correct
time. EPG and timers will not operate correctly if the Local time not set correctly.