Operation Manual

EchoStar User Interface Initial Installation Section 1
S/W Version 1.0 Page 1 - 3
© 2003 EchoStar International Corporation
All rights reserved
English
1
3.3. DISEQC 1.2 INSTALLATION
3.4. GOTO X INSTALLATION
CAUTION
On the motorized dish, mind the East and West limits. Failing to do so might cause
damage to your motorized dish installation or other properties.
1. Press the MENU key.
2. Select User data -
Maintenance - Full reset
and press the OK key.
3. Enter Pin-code: 0000.
4. Select Yes.
5. Wait for the Guided
setup menu to appear.
6. Press the EXIT key.
7. Press the MENU key to
start the installation.
8. Select Installation -
Motorized - DiSEqC 1.2
and press the OK key.
9. Select DiSEqC On.
10. For detailed setting
instructions, please refer
to the manual that came
with the motor.
11. Press the MENU key.
12. Select Installation -
System setup - Search
channels and press the
OK key.
13. Select the SAT.
14. Select the Move dish option.
15. Move the dish and find the
satellite.
16. Select the Fine tune option.
17. Move the dish and find the
best signal.
18. Select the Search channels
field and press the OK key.
19. Wait for the search to
complete.
20. Press the OK key.
1. Do the DiSEqC 1.2
installation first.
2. Make sure the channel
search on the satellite is
completed.
3. Press the MENU key to
continue the installation.
4. For detailed setting
instructions, please
refer to the manual that
came with the motor.
5. Select Installation -
Motorized - GoTo X and
press the OK key.
6. Set the My longitude and
My latitude of the dish.
7. Select the GoTo X option
and select On.
8. Press the OK key.
9. Press the MENU key.
10. Select Installation - System
setup - Search channels and
press the OK key.
11. Select the SAT.
12. Allow the motor some time
to move to the satellite.
13. Select the Search channels
field and press the OK key.
14. Wait for the search to
complete.
15. Press the OK key.