Operation Manual

< Pulsports T-101/T-201
1. Fasten the fastener at one end, put the chest belt on your chest
and loosen the stretch band. (Fig. 1, 2 and 3)
2. Adjust the length of the stretch band until you feel conformable, but
the stretch band must cling to the chest; then fasten the fastener
at the other end. (Fig. 4)
3. Adjust the sensor to the center of your chest and be sure the
backside of the sensor is clings to your chest and touches the skin.
(Fig. 5. 6)
4. The chest belt has to be worn while using the heart rate function.
The distance transmission should be less than 1 meter (3 feet).
5. Do not bend or fold the chest belt to preventing damage. (Fig. 7)
KEY OPERATION
Basic key operations
z SET Hold 2 seconds to enter data setting mode.
z T. M OD E Change watch function group.
z E.MODE Change pulse function group.
z ST/SP Start/Stop
z LAMP EL Light (light 3 seconds for each press).
z BEEP Hold 2 seconds to on/off chime and key beep.
z LAP Record Lap data.
z LAP
_
RECALL Record Lap data review.
Data setting key operations
z SET Press to quit data setting.
z T. M OD E Press to increase the value.
Hold to increase the value automatically.
z E.MODE Press to change the setting value.
z ST/SP Press to decrease the value.
Hold to decrease the value automatically.
E-4