User's Manual

Sys. update: If this option is chosen, the time written in the display

is updated using only the internal circuitry of the RTU itself. Conse-

quently, if your Iridium system is turned off and the on again, the

clock will be reset to a default time. The correct time must then be

set again manually each time.

GPS update: If this option is chosen, the time written in the display

is updated using the connected GPS, if any. Consequently, even if

your Iridium system is turned off and then on again, the clock will still

be adjusted to the correct time each time a GPS update is received.

If no GPS is available, it makes no sense choosing this option.

Setting Dimmer and Contrast

To adjust the background light and the contrast level, first press the

two keys:

The dimmer/contrast menu appears:

Now, move to the desired item – dimmer or contrast – by means of:

Then, to select the item, press:

An Example

When you select dimmer in the dimmer/contrast menu, the display

shows the dimmer menu:

To enable or disable the light, select the On or Off item respectively.

To adjust the dimmer level, select the Level item.

Then, to increase or decrease the dimmer level, use:

For the changes to take effect, press:

The dimmer/contrast menu may also be entered via the “Setup”

menu as follows:

1. To enter the function menu, press:

2. To select the “Setup” item, press:

3. Find the “Light” item using and press:

GPS

Via this menu item, it is possible to obtain the geographical position

in terms of longitude and latitude if an optional GPS receiver is

connected via the transceiver. If this is the case, the position is

available by going through the following steps:

1. To enter the function menu, press:

2. To select the “Setup” item, press:

3. Find the “GPS” item using and press:

DIM/CONTRAST

>Dimmer

Contrast

DIMMER

>On

Off

Level

0125