Specifications

B-FOCuS O-4F2P Installation
ECI Telecom Ltd. Proprietary 3-9
Figure 10: B-FOCuS O-4F2P has not yet been provisioned
Figure 11: B-FOCuS O-4F2P has already been provisioned
1. Verify that the POWER LED lights green indicating that local power level
is good.
2. Verify that the OPTICAL LED lights green indicating that the B-FOCuS O-
4F2P is operating normally.
If the B-FOCuS O-4F2P has already been provisioned in the network, the
OPTICAL LED lights green after the B-FOCuS O-4F2P boot sequence and
PON ranging process is complete (approximately 1 minute after power up).
During that ranging process, the OPTICAL LED flashes continually.
The B-FOCuS O-4F2P is placed into service remotely through the OLT.
Services to the B-FOCuS O-4F2P are likewise provisioned and turned up
remotely through the PON network.
3. If the OPTICAL LED lights green, indicating that the B-FOCuS O-4F2P is
communicating with the PON network, no further activation is necessary
and you can proceed to Section Verifying Services.
4. If the OPTICAL LED does not lig
ht green, contact the NOC
(Network
Operation Center
) to activate the line. You may be required to provide or
confirm the following information about the B-FOCuS O-4F2P: vendor,
model number, serial number. Once the B-FOCuS O-4F2P has been
activated in the network, and the OPTICAL LED lights green, you can
proceed to Section Verifying Services.