Specifications

B-FOCuS 270/285/400 PR Configuration Manual
ECI Telecom Ltd. Proprietary 13
4.2.3. PPP Over Ethernet
In this configuration, additional management services can be activated, like
authentication and efficient bandwidth management (by closing inactive sessions).
Additional parameters should be defined:
• User name, password and authentication protocol (in most of the cases PAP is
used).
• Whether the call is connected constantly (Direct) or the connection is established
only when real communication activity with the WAN is performed (Auto).
• In Auto state, define the length of idle time after which the call is disconnected.
In PPP configuration, IP addresses for accessing the WAN are supplied by the ISP to
the router. When the router is activating the internal DHCP, it supplies IP addresses to
the computers in the LAN. This must be done to enable surfing the Internet from a
computer in the LAN. In addition, NAPT must be activated to translate IP addresses
between the LAN and the WAN.
4.2.4. PPP Over ATM
In this configuration, authentication services can be activated. These additional
parameters should be configured: user name, password and authentication protocol.
In PPP configuration, IP addresses for accessing the WAN are supplied by the ISP to
the router. When the router is activating the internal DHCP, it supplies IP addresses to
the computers in the LAN. This must be done to enable surfing the Internet from a
computer in the LAN. In addition, NAPT must be activated to translate IP addresses
between the LAN and the WAN.
4.2.5. Adding, Editing and Deleting Configurations
 To add a new configuration:
1. Select the radio button representing the required configuration.
2. Modify the required parameters at the top of the WAN Setup dialog box.
3. Modify the required parameters in the area relevant to the selected configuration.
4. Click Add.
5. Check that the new configuration appears in the table at the bottom of the dialog
box.
 To edit a configuration:
1. Select the line you want to edit from the table at the bottom of the dialog box.
2. Modify the required parameters at the top of the WAN Setup dialog box.
3. Modify the required parameters in the area relevant to the selected configuration.
4. Click Modify.
5. Check that the changes are reflected in the table at the bottom of the dialog box.