Specifications

B-FOCuS 270/285/400 PR Configuration Manual
ECI Telecom Ltd. Proprietary 51
8. Check that the interface you have defined appears in the VCC list.
Note: After connection to the WAN, you will be able to see the IP address allocated by the
ISP (either in the WAN Setup menu or when you login as a PPPoA user).
9. Click Show VCC Quality and check that the traffic shaping parameters appear as
you have defined them.
6.6. Defining PPP Over Ethernet
You can define PPP over Ethernet in two ways. The basic workflow is simple, but
most of the parameters are defined by default. The advanced workflow enables
detailed definition of most parameters.
6.6.1. Basic Workflow
 To define PPP over Ethernet using the basic method:
1. From the Basic operations menu select WAN Setup. The WAN Setup dialog box
appears.
2. Click the PPPoE radio button. Define VPI, VCI and encapsulation type (LLC).
Note that Enable NAPT and Enable DHCP Server are checked by default. Define
user name (<name>@<domain>) and password, as received from your ISP and
select the PAP authentication protocol. Define the Mode; select Direct if the
session is always connected; select Auto and define idle time if the session is
disconnected when there is no traffic.
3. Click Add. Check that a line is added to the table. Note that although NAPT is
enabled, it appears in the table in the Off state. The state will be changed to On
when the router is actually connected to the ISP (after dialing).