Manual

7
Audio outputs connections
MASTER Main power amplifier
BOOTH Booth/Room2 power amplifier
REC Recording
FX Send/Return External effect device (Input and Output)
Monitor Headphones
MASTER output
This stereo output feeds the PA system through balanced XLR3 connectors (31, 32) and an unbalanced RCA
connector (29). The nominal level for MASTER output is set to 0dBV (1V), but can be set to +6dBV using an
internal jumper. The MASTER output level is controlled by the MASTER potentiometer (16).
BOOTH output
Commonly used as an independent local "Booth" output for the DJ. This stereo BOOTH (33) has unbalanced RCA
connections and its level is set at 0dBV (1V) but can be changed to +6dBV (2V) through internal jumpers. The
BOOTH level controlled by the BOOTH (17) potentiometer.
Record output
This output pair uses RCA type connectors. REC (37) is placed on the rear connection panel. The nominal level of
the REC output is 0dBV(1V). This output is taken post-fader, before the MASTER signal.
FX Send/Return effects loop
The RCA connectors on the FX SEND output (27) and the FX RETURN input (28) allow creating a signal loop for
external effects processors, samplers or sequencers. The nominal level for the SEND output, as well as for the
RETURN input, is 0dBV (1V).
The signal sent to the FX SEND output can be taken before or behind the fader using the PRE/POST switch (10)
and the send level can be set using the associated potentiometer (11).
Headphones
In order to obtain a high performance, these should be of the high impedance type (200-600Ω). Plug them to the
MONITOR (26) output, in the front panel, by means of a standard 1/4" stereo jack. Sleeve is Ground, Ring is Right
Channel and Tip is Left Channel.