Manual

4. QUICK START

Install and connect the NUO2.0 as described in the INSTALLATION paragraph nº1.

We will describe a “Quick Start” procedure using the LINE input of channel 1 and headphone monitoring output

only.

1. Set the controllers to their initial position

Set Channel 1 GAIN, HI, MID, LOW (2, 3, 4, 5) rotary controls to their

detented centre position. Set the channel fader (12) to its down position.

2. Connect the headphones

Connect them to the headphones output (26). Set the headphones LEVEL

controller (24) to minimum level and move the SELECT (25) controller into

PFL position.

3. Connect a CD player

Connect a CD player to LINE input on channel 1 (35), insert a CD and play

the CD.

4. Connect the mixer's power cable

Connect the power cable to the mixer’s power supply input (39) and turn it

on using the MAINS INPUT switch (40). Both elements are located on the

mixer’s backside.

5. Select the input source

Make sure that channel 1’s input switch (1) is in LINE position and press the

PFL button (9). The PFL VU-meter (14) should highlight. If this doesn’t

happen, verify that the CD player is correctly connected and that there is an

audio track being played back.

6. Adjust the input level

Move the GAIN (2) control until the VU-meter shows 0dB.

7. Send the signal to the main output

Move the fader from channel 1 (12) all the way up and set the crossfader

(13) to the left side.

8. Listen to the signal with your headphones

Adjust the LEVEL controller (24) to obtain a comfortable monitoring volume.

Now you should hear music with your headphones. Turn the SELECT

controller (25) to the right to crossfade the PFL signal and the MIX signal.

When this controller is completely turned to the right, only the MIX signal

will be monitored.

9. Try the operation of the tone controllers

Experiment with this powerful 3-way stereo equaliser (3, 4, 5). This tone control has been designed for a creative

sound edition: each way can be individually isolated using the big and ergonomic rotary controllers.

10. Adjust the crossfader curve

The XFADER SHAPE control (23) allows you to precisely adjust the skew angle of the crossfader’s curve. Turning

the controller completely to the left, the two songs will be melt softly. The crossfader’s curve raises when turning

the controller to the right. Moving the controller completely to the right, the signal will enter suddenly with just a

short movement of the crossfader, which is a very suitable feature for scratching techniques.