User manual

7
3.2 Audio outputs connections
Out 1 Main power amplifier
Out 2 Booth/Room2 power amplifier
Recording top Recording device 1
Recording rear Recording device 2
External Loop External effect device
(Send and Return) (Input and Output)
Headphones Headphones
- Master Output 1:
These stereo outputs feed the main house P.A. system through a XLR3 Balanced connections. The OUT 1 (48/49)
level is set at 0dBV (1V) but can be changed to +6dBV (2V) through soldering bridges. OUT 1 is controlled by
MASTER 1 (35) level potentiometer.
Nearby the MASTER 1 control, a R+L button (34) sums both Right and Left mix signals in the OUT 1 and 2. This is
an extremely useful feature in case one channel of a sound source fails during the session (turntable needle
contact failure in Club is a typical example). Activating this button, the mixer sends the L+R signal to both speakers.
So the problem gets unnoticed by most of the audience.
OUT 1 additionally features a balance control BAL (37) nearby the MASTER 1 control.
- Master Output 2:
Commonly used as an independent local «Booth» output for the DJ. This stereo OUT 2 (50) has unbalanced RCA
connections and its level is set at 0dBV (1V) but can be changed to +6dBV (2V) through soldering bridges. The
OUT 2 level controlled by the MASTER 2 (36) potentiometer.
Nearby the MASTER 1 control, a R+L button (34) sums both Right and Left mix signals in the OUT1 and 2.
- Recording Outputs:
All these outputs use RCA type connectors. REC 1 (47) is placed on the rear connection panel, while the REC 2
output (39) is located on the control surface. These two REC outputs are connected in parallel, but can be
nevertheless used simultaneously. The nominal level of all REC outputs is 0dBV(1V).
- External loop:
The RCA type EXTERNAL FX output SEND (45) and input RTN (46) allow you to create an external loop with any
effect, sampler or sequencer device. The signal sent to EXTERNAL FX SEND output is selected by the FX SEND
buttons available on each channel.
The nominal level of the SEND output and RTN (Return) input is 0dBV(1V).
- Headphones:
In order to obtain a high performance, these should be of the high impedance type (200-600Ω). Plug them in of the
two PHONES outputs (21), in the front panel or top panel, by means of a standard stereo jack. Sleeve is Ground,
Ring is Right Channel and Tip is Left Channel.