Owner`s manual

− 3 −
ENGLISH GERMAN FRENCH ITALIAN SPANISH
On a floor or shelfOn a floor or shelf
Screws X4
Speaker base cover
Safety cable

 Remove the screws from the bottom of the speaker base
and keep to hand for use later.

 Stand the speaker upright.

 Remove the cover from the speaker base.

 Remove the safety cable from the speaker base.
Speaker base
Screwdriver

 Spread a soft cloth over the floor in order to prevent
damaging the surface of the speaker.

 Place the speaker on its side.
- Adjusting the angle of the speaker arm -
󰝟
Speaker
󰝟
Speaker
Speaker base
Screw
Screwdriver
Keep screws to hand for use later.
Tip
･ If you wish to use the speaker at the standard angle position (as it is when removed from its packaging), there is
no need to adjust the angle.
･ You can increase the speaker angle by 15° from its standard position (as it is when removed from its packaging)
by adjusting the speaker arm. (The angle of the speaker [including fine adjustments󰜏refer to P.32] can be
adjusted by up to a maximum of +30°.)
Tip