Owner`s manual

− 35 −
GERMAN FRENCH ITALIAN SPANISHENGLISH
Speaker arm side with
mark

Remove the retaining bolt and the angle adjustment bolt
from the speaker arm side with the mark.

 Install the retaining bolt to the speaker arm side with the
mark.

Set the angle of the speaker arm so that it is aligned with
the mark, and then tighten the angle adjustment bolt.
Mark
：
Speaker arm
Speaker arm side with mark
Angle adjustment bolt
Speaker cone
󰝟
Speaker
󰝟
Speaker
Speaker cone
･ When the retaining bolt and locking screw have been
removed, ensure the speaker does not fall forwards
so neither the cone or cabinet is damaged.
･ Be careful not to get your hand or fingers caught in
the movable part of the speaker arm.
Caution
･ When the retaining bolt and locking screw have been
removed, ensure the speaker does not fall forwards
so neither the cone or cabinet is damaged.
･ Be careful not to get your hand or fingers caught in
the movable part of the speaker arm.
Caution
Speaker arm
Retaining bolt
Angle adjustment bolt
Angle
adjustment
bolt
Fixing holes
󰝢Hexagonal wrench
(small)
󰝡Hexagonal wrench
(large)

 Spread a soft cloth over the floor in order to prevent
damaging the surface of the speaker.

 Place the speaker on its side.
The fixing holes at the and marks on the
speaker arm will not be used.
Tip
Remember to refit the locking bolt after adjusting the
angle.
Tip
The fixing hole at the  mark on the speaker arm will
not be used.
Tip
Retaining bolt
Retaining bolt