Owner`s manual

Introduction

5 Display angle adjustment

Adjust the angle of the display

The screen viewing angle can be adjusted to any of 6 tilt positions when

the light from outside the vehicle makes viewing difficult.

Hold down for more than one

second.

• Each press changes the degree of the slope in

stages. The degree of the slope changes by 5

each time, up to a maximum of 30°.

• Be careful not to pinch your hands or other objects when adjusting the angle of the

display. This could cause an injury or damage to the display.

• When the display is in the TILT status, do not insert a disc or anything else into the

gap at the top. This may damage the main unit and the disc.

• Observe the following cautions when adjusting the angle of the display.

When setting the tilt, make sure there is no interference generated from your hand or

other obstructions setting when either in Park, Reverse or Neutral. (If there is

interference when in Drive, do not set the tilt.)

When setting the tilt, make sure there is no interference generated from your hand or

other obstructions when either in 1st, 3rd, 5th or (Reverse) gear. (If there is

interference, do not set a tilt position.)