Owner's manual
-
14
-
CAUTION
● Do not remove the plug from the power outlet by pulling on the cable.
This can damage the cable, leading to fire or electric shock.
● Do not insert or remove the power plug with wet hands.
This can lead to electric shock.
● Do not run the power cable close to hot equipment.
The insulation on the cable will melt, leading to fire or electric shock.
● Plug the power supply plug into the outlet up to the base of the pins. If it is incompletely
inserted, heat will be generated and may lead to a fire when dust settles. In addition, anyone
touching the pins of the plug may sustain an electric shock.
● Do not connect to a power outlet in which the power plug is loose even though it has been
inserted up to the base of the pins. Heat will be generated and may lead to a fire. Request an
electrician to inspect the outlet.
● If dust or metal debris adheres to the pins of the power plug or close to them, take the power
plug out of the outlet and remove the dust/metal with a dry cloth. Using the plug with the
dust/metal present can lead to fire or electric shock.
● Do not place the amplifier in or overhead or unstable locations, such as on a rickety stand or a
platform with a slope. The amplifier may fall, leading to injuries or product failure.
● Do not place the amplifier in a location where it will be exposed to oil smoke or water vapor,
such as next to a kitchen table or humidifier. This can lead to fire or accidents.
● Do not place the amplifier in a location where it is struck directly by a cool air stream.
This can lead to condensation, current leakage or burning.
● Do not place the amplifier in a location where it is exposed to direct sunlight for long periods of
time or close to heating equipment. This can lead to deformation or discoloration of the
cabinet, or to fire.
● Do not place the amplifier in any extremely cold location.
This can lead to product failure or accidents.
● Do not place the amplifier close to naked flame.
This can lead to product failure or accidents.
● If there is any radio interference due, for example, to proximity to a tuner, install the tuber and
amplifier at a greater distance from each other.
● Before moving the amplifier, first switch off the power supply to the connected devices and
disconnect the power supply cable, the connecting cables to each device, the speaker cables,
and so on.
If you move the amplifier with the cables connected, a cable could be damaged, leading to fire
or electric shock.
● Before cleaning/caring for the product, be sure to switch off the power supply and remove the
power cable plug from the power outlet. Otherwise you could sustain an electric shock or
injuries.
● If you do not use the amplifier for a long time, for example when you are on vacation, for the
sake of safety always switch off the power supply and remove the power cable plug from the
power outlet.
Otherwise there will be a danger of fire.
● Before connecting a TV or any other audio device, be sure to switch off the power supply,
carefully read the instruction manuals of the devices involved, and make the connections in
accordance with the directions in these manuals.
● Before turning on the power, make sure that the volumes of the subwoofer and the amplifier are
set to minimum.
Otherwise a very loud noise could suddenly be generated, causing hearing impairment or other
problems.
● If you hear an abnormal sound while the audio equipment is operating at a high volume, turn
the volume down.
If you continue to use the amplifier at the high volume, or use it for a long time while it is
producing distorted sound, the speaker will heat up, and this could lead to fire.
ENGLISH