ECLIPSE E:A, XA, and ZA Series Amplifiers S~&~wit4.&d#uu Owner's Manual Amplificateurs E:A, XA et ZA Manuel du proprietaire L'e~ 4~ti~ .wee &d#uu E:A, XA, l.d ZA Serie de Amplificadores MUal del Usuario .
For your safety in using the EA, XA and ZA Series Amplifier Warnings and caution signs, illustrated below, are posted throughout this manual. They show safe and correct ways to handle the product to prevent personal injury to you and others and to avoid damage to property. Before reading through the manual, take time to read through and learn the important information listed in this section.
About Your Amplifier Thank You for Your Purchase of this Eclipse Mobile Power Amplifier. Your Eclipse Power Amplifier was Designed and Engineered in the USA for the best in performance and Manufactured with the best components possible. In order to realize the best performance in your system we recommend a professional installation by an authorized Eclipse Dealer.
Installing the Amplifier 2. Mounting the Amplifier: After a suitable location has been selected and the wires routed, the Amplifier can be attached to the Vehicle. Start out by removing the Polished Aluminum Trim Covers from the top of the Amplifier so the Mounting Hardware and the Wire Connections can be made. Set these aside in a safe location so they can be reinstalled after the Amplifier installation is complete.
Adjusting the Amplifier Crossover Frequency Selection: Please refer to (Fig 1) for a reference to frequency Selection for different models of Amplifiers. 1. 2. Select the filter type based on the Amplifier Model and the Application Type. "Hi Pass or Low Pass" Select the Crossover Frequency for Your type of Application and adjust the Control on the Amplifier. Refer to the Diagram for frequency position J: - (J) -I 80 I 58 C> \ Z I ~~-~\ 50 " W 46 / /140 45 - ' '~~/ I / 70 I 100 I ~..
Amplifier Gain Adjustment: *If a subwoofer level control is used with this application at this time Turn the Control full Clockwise (up all the way). 1. 2. Adjust the sensitivity controls full counterclockwise C8 V setting ). Use a CD or DVD with High Energy Music and adjust the Gain to about 80% of the Source Units Maximum output. Make sure the Balance and Fader are in Center Positions. Make sure the Bass and Treble are boosted on the Source Unit.
Troubleshooting If a problem occurs after your system is installed, please refer to this troubleshooting section for solutions. Problem J: 1. Amp wont power on -en ~ (!) .:z Possible Cause No fuse installed in the amplifier or fuse is blown.
Troubleshooting Problem 4. Amplifier goes into protect mode Possible Cause One or more speakers are shorted Possible Solution Make sure there are no speaker shorts: With the amplifier turned off disconnect speaker from amp and test for a short across the Speaker. Test for a short between the speaker and chassis or body of the car. With the speakers connected and amp turned off Test for a short between the amplifier output And the chassis or body of the car. 5. Amp has engine noise 6.
Troubleshooting Possible Cause Possible Solution Gain Control for Subwoofer is too low Check Source Unit settings and Input Gain Control: Adjust gain control on Source unit or at amplifier Input. J: Crossover is set up incorrectly Check crossover freguency settings: Adjust Crossover (!) Subwoofers are wired out of phase Check subwoofer wiring and phase: Correct wiring of subwoofer to be in phase.
Trou bleshooting 11. Amp runs hot 12. Amp wont shut off Inadequate ventilation Make sure unit has proper ventilation: Load impedance is too low Check load impedance against the specifications: Connect the proper load impedance. Remote on wire is staying high or at 12V Measure voltage between Remote on terminal and the power ground terminal: If the voltage is high disconnect the Source Unit And see if the amp shuts off. If it does try a different source unit.
Specifications EA4200 / XA4200 Power Output: RMS Power at 14.4 Volt Power Supply @ CEA 2006 EA4200 40 @ 20 Hz to 20 KHz Stereo 60WX4 I 20 @ 20 Hz to 20 KHz Stereo 70WX4 ~ 40 @ 20 Hz to 20 KHz Bridged 140W X 2 ...J XA4200 C) Z W 40 @ 20 Hz to 20 KHz Stereo 100W X 4 20 @ 20 Hz to 20 KHz Stereo 200W X 4 40 @ 20 Hz to 20 KHz Bridged 400W X 2 Max Power Output: Peak Music Power at 14.
Specifications XA1200 / ZA1200 Power Output: RMS Power at 14.4 Volt Power Supply @ CEA 2006 XA1200 40 @ 20 Hz to 20 KHz Mono 20 500W X 1 500W X 1 @ 20 Hz to 20 KHz Mono ZA1200 1000W X 1 40 @ 20 Hz to 20 KHz Mono 20 1000W X 1 @ 20 Hz to 20 KHz Mono Max Power Output: Peak Music Power at 14.4 Volt Power Supply XA1200 40 Mono @ 1 KHz 700W X 1 ZA1200 40 Mono 1200W X 1 @ 1 KHz 1.
Controls EA4200 ! • J i. I en - o dB 8 9 .....J .(9 W FILTER lOW, rHI 1-3 Hi / Lo Pass Filter Selection Switch (Front and Rear) MONO OfF, rON ~[CJ ! 2-4 Mono Selection (Front / Rear) 5G{Q} 7G8g G 10G BASS BOOST Z ~ 3 2 FILTER MONO LON, rHI OFF, rON CROSSOVER BASS BOOST 30 Hz 500 CROSSOVER 0 dB 8 -INPUT 5-7 Bass Boost (Front / Rear) 6-8 Crossover adjustment (Front / Rear) 30 Hz 500 9-10 Input Level (Front / Rear) -INPUT 8 V 12 8 V 1.
Controls XA1200 1~-_O_~ FRONT 2 rffiffIl ~ €) OJ ~~ OJ 8 V 1.2 INPUT LEVEL ~ 6 3 LEVEL CONTROL , I , '.~'-"" -,/ \ "•. ' \ ,\.~/, 45 Hz 200 32 Hz 64 , , o Db 8 LOW PASS FREQ LEVEL IT 2 BASS BOOST 1 Line Input 4 Low Pass Filter Frequency Selector. 2 Input Level 5 Bass Boost Frequency Selector 3 Bass Level Control 6 Bass Boost Level Control FUSE 40A SPfAKER OUT +BATT REMOTE GND 40A ".--~" ,~_/' DoD " ,,-, ----' '~'~~I W /--- ........ \_---~ I .
(ECLIPSE . Fujitsu Ten Limited Contact: Fujitsu Ten Corp. of America 19600 So. Vermont Avenue, Torrance, CA 90502 Call: (800) 233-2216 www.eclipse-web.com Fujitsu Ten Limited Communiquez avec: Fujitsu Ten Corp. d'Amerique 19600 So. Avenue Vermont, Torrance, CA 90502 Telephonez au : (800) 233-2216 www.eclipse-web.com Fujitsu Ten Limited Contacto : Fujitsu Ten Corp. d'Amerique 19600 So. Vermont Avenue, Torrance, CA 90502 L1ame: (800) 233-2216 www.eclipse-web.
LECLIPSE i Fujitsu Ten Corp. of America Garantie limitee du consommateur Garantie valable uniquement aux E.U. et au Canada Cette garantie limitee fournie par Fujitsu Ten Corp. of America ("Eclipse") couvre, sous utilisation normale, toutes defectuosites materielle et main d'ceuvre de votre nouveau produit Eclipse achete chez un detaillant agree Eclipse aux E.U. ou au Canada, pendant une duree de une (1) annee a compter de la date d'achat d'origine.
Fujitsu Ten Corp. of America Consumer Limited Warranty Warranty valid only in the U.S.A. and Canada This limited warranty provided by Fujitsu Ten Corp. of America ("Eclipse") covers all defects in materials or workmanship under normal use in your new Eclipse Product purchased from an authorized Eclipse retailer in the U.S.A. or Canada for a period of one (1) year from the date of original consumer purchase.
