MSDS
Lastrevised9/30/2008ECOBONDAdhesivesHD150MaterialDataSafetySheet
If this product as supplied becomes a waste, it does not meet the criteria of a hazardous waste as defined under the
Resource Conservation and Recovery Act (RCRA) 40 CFR 261.
This product becomes a firm synthetic rubber when cured. Please allow to cure before disposal.
Special Shipping Information – None.
DOT – Not regulated.
TDG – Not available.
PIN – Not available.
OSHA 29 CFR 1910-1200 – Irritant.
TSCA – All components of this product are listed on TSCA Inventory.
CERCLA Reportable Quantity – Not applicable.
SARA Title III:
Section 302 Extremely Hazardous Substances – None.
Section 304 – Not applicable.
Section 311/312 – Immediate (acute) health hazard.
Section 313 – None.
RCRA – Refer to section 13.
California Proposition 65 – To the best of our knowledge this product contains no levels of listed substances which the
state of California has found to cause cancer, birth defects or other reproductive
harm.
WHIMS Classification – D2B
Prepared in accordance with 29 CFR 1910.1200
This Product has been classified in accordance with the hazard criteria of the Controlled Products Regulations (CPR)
and the MSDS contains all of the information required by the CPR.
HD 150 is an ECO-BOND trademark
To the best of our knowledge, the information contained herein is accurate. However ECO-BOND Adhesives, LLC
does not assume any liability whatsoever for the accuracy or completeness of the information contained herein. Final
determination of suitability of any material is the sole responsibility of the user. All materials may present unknown
hazards and should be handled with care. Although we have described herein all of the hazards to which we are
currently aware, we cannot guarantee that these are the only hazards which exist.
Section13.Dis
p
osalConsiderations
Section14.Trans
p
ortInformation
Section15.Re
g
ulator
y
Information
Section16.OtherInformation