User's Manual

Advanced Settings

These options customize how long each stage will run before the next

stage turns on. You may also program when a particular stage is turned

on based on the temperature delta between the set temperature and the

current temperature.

d Reverse Staging If enabled, the thermostat will cycle down from

the higher stages so that when it approaches set point it will only

be running in stage 1. The thermostat calculates which stage to

start the HVAC equipment in depending on the indoor tempera-

ture and set point temperature delta. The HVAC equipment will

start in stage 1. As the stage 1 temperature delta is exceeded, the

second stage will engage. Once the equipment has brought the

current temperature back to within the heat or cool differential

setting, stage 2 will disengage and stage 1 will remain running

until the set point is met.

d Stage 2 Temp Delta The minimum difference between the cur-

rent temperature and the set temperature that will activate the

auxiliary heat (regardless if the maximum run time of the previ-

ous stage was reached). Options are Auto (default) and 1 to 10° F

(0.6 to 5.6° C).

d Stage 1 Max Runtime The maximum amount of time stage 1

will run before engaging the next stage. Options are Auto (de-

fault) and 10 to 120 minutes.

d Comp to Aux Runtime The maximum amount of time this stage

will run before engaging the next stage. Options are Auto (de-

fault)and1to10° F(0.6to5.6° C).

d Comp to Aux Temp Delta The minimum difference between the

current temperature and the set temperature that will activate this

stage (regardless if the maximum run time of the previous stage

was reached). Options are Auto (default), Disabled, and 1 to 10°

F(0.6to5.6° C).

d CoolMinOnTimeSets the minimum equipment run time in

cool mode: 1 to 20 min (default is 5 min).

d HeatMinOnTimeSets the minimum equipment run time in

heat mode: 1 to 20 min (default is 5 min).