User's Manual

Temp Correction

Lets you program an offset between the real temperature at thermostat

and the displayed temperature. If you find that the temperature where the

thermostat is located does not represent the room temperature, change the

offset to compensate for the difference. The correct temperature is

adjustable from +/-- 10° Fin0.5° F(0.3° C) increments.

Installer Code

To prevent accidental modifications to the installation settings, you can

enable a 4 --digit installer code. This code is pre--programmed to 3262.

Test Equipment

These options let you test the wiring and connections of the devices

connected to the thermostat by turning them on or off.

The equipment will turn off when you exit the menu.

EQUIPMENT DAMAGE HAZARD

Failure to follow this warning could result in equipment

damage.

Compressor protection and minimum run --time features are not

enforced while in this mode.

WARNING

To test the equipment:

From the Home screen, press MENU.

Select Settings " Installation Settings.

Select Test Equipment.

Select OK.

Test the equipment connected to the thermostat by turning each

component on and off.