User's Manual

Temp Correction
Lets you program an oset between the real
temperature at thermostat and the displayed
temperature. If you nd that the temperature
where the thermostat is located does not
represent the room temperature, change the
oset to compensate for the dierence. The
correct temperature is adjustable from +/- 10°F
in 0.5°F (0.3°C) increments.
Installer Code
To prevent accidental modications to the
installation settings, you can enable a 4-digit
installer code. This code is pre-programmed to
3262.
Test Equipment
These options let you test the wiring and
connections of the devices connected to the
thermostat by turning them on or o.
The equipment will turn o when you exit the
menu.
Warning: Compressor protection and
minimum run-time features are not
enforced while in this mode.
To test the equipment:
From the Home screen,
press MENU.
Select Settings ▶
Installation Settings.
Select Test Equipment.
Select OK.
Test the equipment
connected to the
thermostat by turning each
component on and o.
!
Reset HVAC Equipment Settings
You can quickly restore all HVAC equipment
settings on the Smart Si thermostat back to their
factory defaults. Any user setting (not related to
the equipment installed) will remain unchanged.
If you need to reset the entire thermostat back
to its original factory default settings, including
user settings and registration, select Reset All
Settings instead.
Performing a Hardware Reset
In rare circumstances, static electricity or power
surges may interrupt the operation of the
thermostat, forcing a hardware reset.
Rebooting the Smart Si
Thermostat
You can reboot the Smart Si thermostat by
pressing the physical hardware reset button,
located through an opening in the bottom left
corner of the Smart Si thermostat. Rebooting
will not alter programming or conguration
options.
To reset the Smart Si
thermostat:
From the Home screen,
press MENU.
Select Settings ▶ Reset.
Select HVAC Equipment
Settings.
Select Ye s.
Reset button
2
7