User's Manual

LICENSEE to be performed in a timely and complete manner, shall impair any
such right or power or be construed as a waiver of any succeeding breach or
any other covenant. Any waivers by ecobee must be in writing and signed
by an authorized representative of ecobee. If any provision of this EULA is
held by a court of competent jurisdiction to be invalid or unenforceable in
any respect, then the remaining provisions of this EULA, or the application of
such provisions to persons or circumstances other than those as to which it is
invalid or unenforceable shall not be aected thereby, and each such provision
of this EULA shall be valid and enforceable to the extent granted by law. The
EULA constitutes the entire agreement between the parties as it relates to the
license and use of the Software and User Manual and the subject matter of this
EULA and supersedes all prior or contemporaneous agreements, negotiations,
representations and proposals, written or oral between ecobee and LICENSEE. The
EULA may only be amended or supplemented by written agreement executed by
each of the parties.
Approvals
This product was designed and built in accordance to RoHS directive 2002/95/EC
and contains no hazardous substances as defined by this directive.
Federal Communications Commission (FCC)
Compliance Notice:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o[ and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
6
3