Warranty
ECOBOND
®
LBP: Lead Defender
®
PRO
Lead Based Paint Sealant and Treatment,
Latex Primer and Paint
DEFENSE AGAINST LEAD PAINT HAZARDS
RECOMMEND FILM THICKNESS
Single coat 4-6 mil wet for typical
application
Incrementally layer up to 12 mil
wet for higher concentrations of
lead
COVERAGE
250-300 sf/gal depending on surface
texture, porosity and application
method
APPLICATION TEMPERATURE
50
o
– 100
o
F
APPLICATION TOOLS
Airless Sprayer: Recommended
tip size .021-.033, filters removed
Roller: High quality ½ - ¾ “ nap
Brush: Nylon/polyester blend
DRY TIME AT 77
O
F, 50% RH
To touch: 2-4 hours
To recoat/topcoat: 4 hours
Application at lower temperatures,
high humidly, or poor ventilation will
affect dry time.
PROPERTIES
Fill/Max Tint (oz)
124/4 per gal.
VOC
<15 g/L
Flashpoint
N/A
Composition
Vehicle
Acrylic Polymer
Weight Solids
17.5% (
+/-
2%)
Volume Solids
21.8% (
+/-
2%)
Wt: 1 Gal
12 lbs
Wt: 5 Gal
57 lbs
Viscosity
90 kµ
PRODUCT TESTING
EPA Method 1311: Reduces lead
hazards by up to 95%
ASTM E1613-12: Reduces airborne
lead dust by up to 99%
EPA 9200.1-86: Reduces relative
lead bioavailability by up to 75%
EPA Method 1312: Resists acid rain
PRODUCT DESCRIPTION: Specially formulated for professional use with
patented lead treatment reagents, paint penetrators, paint softeners, and the
best professional-grade quality latex paint to penetrate, bond, seal and treat
existing lead paint applications and control the spread of airborne lead.
Advanced human bioavailability reduction, resistance to acid rain, low odor,
low VOC, quick dry penetrating resin, firm anchorage and paint application
compatibility. For use on interior and exterior surfaces.
WHERE TO USE: Use to seal and treat lead paint/dust as a self-priming
interior paint or as an exterior primer prior to application of standard exterior
topcoat. Ideal for offices, retail/commercial/industrial facilities, DOT
structures, schools, and residential. Superior adhesion on most properly
prepared substrates, the unique Paint-it-on Leave-it-on® formula can be used
on a variety of surfaces including, but not limited to:
Wood
Drywall/Plaster
Steel
Masonry
Brick
Metal
Concrete
Asphalt
SURFACE PREPARATION
Surface must be clean, dry, and
free of dust, rust, grease, oil, and
peeling paint that could interfere
with adhesion
Patch and repair any damaged
areas such as holes and cracks
High Gloss Surfaces may be
prepared by application of a liquid
deglosser and or TSP, rinse well
and allow to dry; High gloss
topcoat applications, may require
scuffing
Prepare Masonry Surfaces by
applying a masonry sealer prior to
Lead Defender® PRO application.
Remove all dust with a damp
cloth, allow surface to dry
APPLICATION
Eye protection is recommended
Apply when air and surface
temperatures are between 50-
100
o
F
Apply as supplied using a sprayer,
roller, or brush
Thoroughly mix prior to use for 1-
3 minutes
APPLICATION (cont.)
Initial testing is recommended by
painting a small area prior to full
application to confirm
compatibility
Protect surface from rain or
moisture until dry
CLEANUP AND DISPOSAL:
Clean spills immediately with
soap and warm water
Wash hands, tools, and
equipment with warm soapy
water after use
Dispose of all waste according to
current local, state, and federal
regulations