Instructions / Assembly

EcoBorder Installation Instructions
Notice - These products are 99.9% steel free. Wear gloves when installing.
Positioning
Carry pieces to the install location by draping them evenly over your arms, with arms extended out in
front of you. It's best to install dry EcoBorder products on dry ground. Position the product high on
ground that may settle. Simply rake some soil underneath to position pieces higher in the bed.
Installations are easiest when you let our products guide you in forming the curves around your
beds. Place the pieces down just inside the edge of the bed flush with the lawn and then connect
them using the provided connector rods. Slide the pieces forward or backward just slightly to close the
gaps so that they match the channels over the top of each piece.
Staking and plugging holes
Once in position, stake the pieces down starting with the holes next to the connections. Then come back
and use the remaining stakes to hold down the areas in between. More stakes will be used on the curves
and less on the straight runs. Please note that the stake holes are tilted toward the front of the edging to
maximize the holding power. If using a hammer with a large head or if it is difficult to finish the stake
you can use a second stake or a tap in the dimple to finish the stake firmly into place. Use the provided
plugs if wish to hide the stake holes. Push the shallow part of the plug in and towards the front of the
edging, then push the rest of the plug down into place.
Turns
Please note that the EcoBorder can bend up to 90 degrees. Do not over-bend the product; let it guide you
in making natural, gradual curves around your beds. When making sharp curves the product will
naturally tilt forward. This is by design, let the product bank the curves for a dynamic effect in your
landscape.
Cutting
If a cut is needed, cut with a handsaw, hacksaw, or electric saw. Use a miter box for a more accurate cut.
If using an electric saw, give the blade a light spray of lubricant to aid in the cutting. If the connector
holes need to be deepened or adjusted, drill with a 3/16" bit. The connector rods are 3" long so the end
hole in each piece is 1.5" deep. Drilling templates for the end holes are available on our website. Square
corners may be miter cut just like moulding; with a 45 degree cut at the end of each piece.
For more info, please visit our website at www.EcoBorder.com
and/or simply email us at
[e-mail] .
Thank you, The EcoBorder Team.
Always wear safety glasses when cutting materials.