Energy Guide
!
!
!!!!!
!
!!!!!!!!!
!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!
!!!!
!!
!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!
!!!!!!!!!!!!!!!!!!!!!!
!!
Contact:
Sharon McNamara
888.509.2420
sharon@ecobust.ca
ECOBUST CASE STUDY: CUTTING-EDGE DEMOLITION
Demolition jobs can be difficult and dangerous. When access to the demolition site is limited,
safety and strategy become even more critical.
A demolition crew needed to expose rebar on the edge of a building so a new structure could be
tied to the existing one. The concrete lip was ten inches thick. Using a jackhammer on the edge
would be dangerous, and the safety issues made the job more expensive, as work
ers were required
to follow proper fall arrest procedures that added time.
It would take a two-man crew eight hours to complete the job for an estimated $452. Using the
Ecobust method, one man was able to drill the holes in the lip, mix and pour the solution into the
holes, and chip away the concrete from the rebar in three hours. The cost of labor and equipment
rentals was $214 – half the cost of the traditional method.
Ecobust is easy enough for the everyday job, but powerful enough for pr
ofessional needs. It’s an
effective alternative for precision jobs where traditional processes won’t work.
Ecobust Distribution International Inc. distributes and supports the fastest, most powerful non-explosive demolition agent for
breaking rock or concrete. Through its distribution and retail centers, it provides a safe, environmentally friendly, non-toxic
chemical compound that is simple to use and breaks all forms of rock and concrete quickly and easily.
For additional informati
on, visit www.ecobust.ca and follow them on Twitter at twitter.com/ecobust.
!