Specifications

15
Step E: Install RO Faucet (cont.)
BLACK TUBE
3/8” barb fitting
for the black tube
RED TUBE
1/4” barb fitting
for the red tube
BLUE TUBE
3/8” quick connect fit-
ting for the blue tube
Faucet
Connect to
electronics
in manifold
INSTALL REVERSE OSMOSIS FAUCET
1. Locate and organize your RO faucet install parts. Refer to
Fig. 16.
2. Snap the o-ring into the groove on the bottom of the ring
and slide the monitor ring onto the faucet stud. The monitor
ring LED wire must be routed through the sink or counter-
top hole and through the spacer, if used. See Fig. 16.
3. Locate the 3/8" black tubing and push one end onto the
3/8" faucet barb fitting, see Fig. 17.
4. Move the RO system into position, under the sink.
(Referring to page 12, hang the system on cabinet wall, or
lay on the floor surface, as desired.)
NOTE: If you routed the red drain tubing directly to a
remote drain point (see page 11), disregard step 5 and
move on to step 6.
5. Route the 1/4" red tubing from the bottom, up through the
faucet mounting hole. Push the end of the tubing onto the
1/4" barb fitting. See Fig. 17.
NOTE: Tubing lengths should allow for the removal of the
assembly from the hanger washers for servicing. If tub-
ing lengths are shortened for neater appearance, it may
be necessary to keep the assembly on the hanger wash-
ers for service.
6. Work tubing and the faucet stud down, into the mounting
hole.
7. On the underside of the sink or countertop, install the spac-
er, plastic bushing, flat washer, and hex nut. Slide the large
steel washer into place between the bushing and spacer.
Then, tighten the hex nut securely. Make sure that the LED
wire is in a position so that it will not be cut, pinched or
kinked before tightening the faucet assembly.
8. Thread the tubing connector onto the bottom of the faucet
stud.
9. Push the end of the 3/8" blue tubing from the RO, into the
tubing connector. See Fig. 17.
FIG. 16
FIG. 17
O-ring
Spacer
Bushing
Hex Nut
Washer
Electronics Ring
Steel Washer
(large)
1-1/4” dia. Hole