Specifications

6
PLAN YOUR INSTALLATION
Read through the entire manual before beginning
your installation. Follow all steps exactly. Reading this
manual will also help you get all the benefits from your
system.
Your Reverse Osmosis Drinking Water System can be
installed under a sink or in a remote location. Typical
remote sites are a laundry room or utility room. Review
the location options below and determine where you are
going to install your system.
NOTE: For best system performance, the feed water
to the system should be softened or have hardness
less than 10 grains per gallon, with no iron.
UNDER THE SINK LOCATION
The Reverse Osmosis Filter Assembly and storage tank
may be installed in a kitchen or bathroom sink cabinet.
See Fig. 4.
A suitable drain point is needed for drain water from the
Reverse Osmosis system.
REMOTE INTERIOR LOCATION
The Reverse Osmosis Filter Assembly and storage tank
may also be installed in a remote interior location away
from the Reverse Osmosis Faucet. You will need a near-
by water source and drain point.
See Fig. 5.
CHECK SPACE REQUIREMENTS
Check size and position of items for proper installation
into location chosen.
TOOLS NEEDED
Review the tools needed list. See Fig. 3. Gather needed
tools before proceeding with the installation. Read and
follow the instructions provided with any tools listed here.
TOOLS NEEDED
Adjustable wrench
Tape MeasurePhillips Screwdriver
Flathead Screwdriver
Drill & Drill bits, if required.
Large Adjustable Jaw Pliers or Pipe Wrench
Plan Your Installation
FIG. 3