User Manual

9205-3000 (FAS1548) Nexa™ Touch Free Dispenser Beacon User’s Guide
Ecolab, Inc.
Ecolab P/N
Revision
Date
Drawing Number
Page
9205-3000
??
03/03/17
???
12 of 14
1. Two (2) alkaline AAA Duracell® Coppertop Batteries
5.3.2 Battery Replacement Steps
The following steps describe how to remove the TDB from the Nexa Touch Free Dispenser, and replace the batteries:
1. Open the dispenser by depressing the top latch button.
2. Remove product bottle (if any) from the dispenser and set aside.
3. Unscrew the retained screw from the boss, to release the beacon and allow it to be removed.
4. Gently grasp and pull on the TDB to disengage the TDB plug from the communication port.
5. Holding the TDB so that battery compartment door is facing up, remove the battery compartment door by
gently pulling back on the battery door tab.
6. Once the battery compartment door has been removed, install two (2) AAA alkaline batteries, aligning the
positive (+) and negative (-) terminals of the batteries with the corresponding signs displayed within the
battery compartment (Ecolab recommends that only Duracell® Coppertop batteries be used to power the
module.)
7. Once the batteries have been installed, replace the battery compartment door and make sure that it is firmly
in place before replacing the TDB in the dispenser.
8. To replace the TDB in the Nexa Touch Free Dispenser, align the TDB plug with the communication port, and
the housing’s captive screw with the screw boss in the back of the dispenser (see figure 4).
9. Gently but firmly insert the TDB plug into the communication port, until it is firmly seated in the port.
10. Tighten the captive screw finger tight into the boss.
11. Replace the product bottle within the dispenser.
12. Close the dispenser.
13. Dispose of the old batteries. Check with the healthcare facility for the proper disposal procedure.