User's Guide

92053070 NEXA HHCM 915 TOUCH FREE DISPENSER BEACON USER’S GUIDE
Ecolab P/N
Page
92053070
3 of 11
Communication
Port Cover
Plug
2.2 Installing the NEXA HHCM 915 TOUCH FREE DISPENSER BEACON in a Nexa™ Touch Free
Dispenser
The NEXA HHCM 915 TOUCH FREE DISPENSER BEACON can be used in either the large (“Classic”) and small (“Compact”)
versions of the Nexa Touch Free Dispenser.
To install the dispenser beacon:
(1) Open the dispenser by depressing the top latch button.
(2) Remove product bottle (if any) from the dispenser and set aside.
(3) Remove the rubber communication port cover in the back of the dispenser (see figure 2) and discard.
(4) Align the plug with the communication port and the housing’s captive screw with the screw boss in the
back of the dispenser (see figure 2).
(5) Gently but firmly insert the plug (adjusting the plug may be necessary) into the communication port, until
it is firmly seated in the port.
(6) Tighten the captive screw finger tight into the boss.
(7) Replace the product bottle within the dispenser.
(8) Close the dispenser.
Figure 2. NEXA HHCM 915 TOUCH FREE DISPENSER BEACON Installation into Nexa™ Touch Free Dispenser
Installation: alignment of
TF CMPCT BCN with
dispenser boss and
communication port
Screw
Boss