User Manual

Document Title UltraClenz, LLC
Page 6
Step 2 – Inserting the Power Supply Wires
With the small flat-tip screwdriver in place, insert the wire with the white stripe on it from the power supply
(positive wire) (see Figure 3) into the circular opening directly beneath the rectangular slot until it stops and pull
out the small flat-tip screwdriver to lock the wire in place. Give the positive wire a slight tug to insure that it is
locked into place. Repeat the process for the rectangular slot of the power connector marked - (negative) on the
back of the hub with the remaining wire.
Note: Please ensure proper polarity before plugging the power supply into an electrical outlet.
Configuring the Hub
The WiNet Hub requires no configuration.
Maintenance of the Hub
Cleaning
The exterior can be cleaned with a NON abrasive detergent and a NON abrasive damp (not wet) sponge or cloth.
The Hub is splash resistant but not water proof.
Figure 3