Certification Exhibit FCC ID: Z9O-FAS1527 IC: 10060A-FAS1527 FCC Rule Part: 15.249 IC Radio Standards Specification: RSS-210 ACS Project: 13-2002 Manufacturer: UltraClenz, LLC Models: FAS1527-00, FAS1527-01, FAS1527-02 User Manual 3998 FAU Blvd.
Patient Safeguard System® (PSS) Healthcare Worker Badge User’s Guide FAS1527 DFU Revision 2 UltraClenz, LLC
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC Table of Contents 1.0 Healthcare Worker (HWC) Badge ..................................................................................................................3 2.0 How the Badge works within PSS .......................................................................................................................4 3.0 Installing the System ..............................................................................
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC 1.0 Healthcare Worker (HWC) Badge The PSS badge is an integral component of the individual reminder system. Badges are assigned to specific healthcare workers (HCW) and may not be interchanged. It is worn by HCWs, such as doctors and nurses. Healthcare facilities may also choose to assign badges to therapists, visitors, students or any persons with patient contact.
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC The badge can be worn at the waist, on a lanyard around the neck, on a chest pocket, inside a chest pocket or under a lab coat. However, the clear window is designed so HCWs and patients can view the current badge status. 2.
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC the HCW remains inside the patient zone, their badge will remain in the reminder state. When the HCW leaves the patient zone, the badge starts an internal timer. If there is no interaction between the HCW and a dispenser, after leaving the patient zone, the timer will continue to increment.
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC 3.0 Installing the System 3.1 Healthcare Worker (HCW) Badge Installation A new badge is supplied with a pull tab to protect battery life during shipment. Remove by firmly pulling this tab out and discarding before initial use. For best performance, the badge should be worn above the waist in a location that is clearly visible to the HCW as well as the patients and other healthcare staff.
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC are assigned to the HCWs. Take care to return the badge to the HCW in which it is assigned upon battery replacement. Tools needed to replace the badge’s battery: Quantity 1 - #2 Phillips head screwdriver Step 1 - Using the #2 Phillips head screwdriver, remove the two back cover screws. Save the screws. Step 2 - Flip the badge over and remove the front cover to expose the pc board and battery holder.
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC Appendix B - FCC and Industry Canada Statements Warning: Changes or modifications to this device not expressly approved by UltraClenz, LLC could void the user’s authority to operate the equipment. Class B Devices: “NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
