Installation Instructions
Table Of Contents
© 2020 Ecolink Intelligent Technology Inc.
PN DWLZWAVE2.5-ECO R1
Network Inclusion: Key Points to Remember
• Controller inclusion mode must be activated BEFORE starting sensor inclusion mode.
• The sensor can only be included into one controller network at a time, and must be excluded from one network before inclusion in another.
• Removing the pull tab connects the battery and initiates sensor inclusion mode. Inclusion mode can also be initiated by removing the battery for
at least 5 seconds, reinstalling the battery, then replacing the sensor cover.
• The plastic pull tab must be removed to enable sensor operation.
• The sensor automatically enters inclusion mode at power-up.
• Exclusion mode on the senor is initiated following the same exact procedure as inclusion.
Ins
tallation
The package contains the following:
1- Light Sensor
1- Sensor Mounting Bracket
2- Screws for Sensor Mounting Bracket
1- Adhesive tape for Sensor Mounting Bracket
STEP ONE Identify Location for Sensor:
Determine where on the mounting surface you are able to mount the sensor.
STE
P TWO Mount the sensor to a clean dry surface with the adhesive tape and/or the screws provided.
Adhesive
Tape
Mounting
Bracket
Screws
(optional)
Sensor