User's Manual

This sensor is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is
fully compatible with any Z-Wave enabled network. The sensor sends a Z-Wave message when a door or
window is opened.
For indoor use only
Operating Frequency: 908.42 MHz
Operating Range: Up to 100 feet line-of-sight
Operating Temperature: 0⁰C to 49⁰C
Battery: CR123A
Notice: If you are installing the entire Z-Wave system for the first time, please refer to the installation
guide provided by the manufacturer of your Z-Wave controller before installing the door/window sensor.
1. Remove the plastic pull tab from the sensor to allow power to flow from the battery. The LED will
start to blink. Removal of the tab will automatically put the sensor into “inclusion mode”, the process
by which the sensor is learned into a Z-Wave network. If the controller already happens to be in
inclusion mode when the tab is pulled, the inclusion process will begin. The sensor will send out two
“node info frames” and the controller will acknowledge with a node ID and a home ID for the sensor.
If the inclusion process is successful, the LED on the sensor will stay lit for up to ten seconds and then
go dark. If inclusion was unsuccessful, the LED will continue blinking and the inclusion process must
be repeated. To enter inclusion mode at any time, make sure the controller is in inclusion mode. You
will need open the sensor’s back case (push down on the latch) and completely remove the battery.
The battery must stay disconnected for ten seconds. When the battery is replaced, check to see if
inclusion was successful by observing the LED. If inclusion was successful, the LED will remain lit
until the cover is replaced. If inclusion was unsuccessful, the LED will continue blinking.
Wireless Door/Window Sensor
Installation & Operation Manual
Introduction
Product Specification
Setup & Installation