User Manual

SS-319 Wireless Siren

Specifications

Frequency: 319.508MHz Operating Temperature: 32°-120°F (0°-49°C)

Battery: 3.6V NiMH rechargeable 3 cell pack Operating Humidity: 5-95% RH non condensing

Battery life upon power loss: 24 hours Compatible with UTC Interlogix panels

Supervisory signal interval: 60 min(approx.)

Installing the Wireless Siren

Connect the Battery

The Wireless Siren uses a NiMH rechargeable battery pack, included. Remove the battery cover on the back of

the siren and insert the battery pack. Plug the battery pack connector to the two pin connector on the Siren.

Reattach battery door.

Mounting

Plug Wireless Siren into constant power AC outlet.

An optional screw mount is available to prevent easily unplugging the device. Using a screw driver or other

tool, remove the thin layer of material in the center of the screw tab on the Siren. Next, remove the center

screw of the wall plate on the AC outlet you are plugging the Siren into. You may either use that same screw

you just removed from the AC outlet, or use the longer screw that is included in the Siren packaging. Place

the cover plate of the AC outlet on, and then plug in the Siren WITH THE SCREW TAB POINTING TOWARDS

THE FLOOR. Insert screw through the Siren screw tab and tighten Siren and wall plate so the Siren is tight to

the wall plate.

Enrolling

To enroll the siren, set your panel into program mode, refer to your specific alarm panel manual for details on

these menus. When prompted by the panel, trigger the siren by pressing the LEARN button on the side of the

siren. If successfully enrolled, you will see the LED flash, and the alarm panel will BEEP.

Enable/Disable Chime Feature

Enable:

• Make sure the chime feature has been turned on in the Interlogix panel first.

• Simultaneously press the LEARN and TEST buttons on the side of the Siren for 2 seconds.

• LED will remain on , and the siren module will BEEP, indicating the chime feature is ON

Disable:

• The chime function can be on or off in the Interlogix panel, this will not affect disabling Wireless

Siren’s chime function.

• Simultaneously press the LEARN and TEST buttons on the side of the Siren for 2 seconds.

• LED will blink off, and the siren will not chirp, indicating the chime feature is Off.

PAGE 1
SS-319 Wireless Siren Specifications Frequency: 319.508MHz Battery: 3.6V NiMH rechargeable 3 cell pack Battery life upon power loss: 24 hours Supervisory signal interval: 60 min(approx.) Operating Temperature: 32°-120°F (0°-49°C) Operating Humidity: 5-95% RH non condensing Compatible with UTC Interlogix panels Installing the Wireless Siren Connect the Battery The Wireless Siren uses a NiMH rechargeable battery pack, included. Remove the battery cover on the back of the siren and insert the battery pack.
PAGE 2
Range Test After the SS-319 Siren has been learned into the panel, an RF range test can be initiated. To do this, press the test button for one second. This will cause the siren to send 8 test packets to the panel, and the LED on the siren will blink each time a packet is sent. As the panel receives each of the 8 packets, it will send an acknowledgement packet back to the Siren. The Siren will chirp each time an acknowledgement is received.