User Manual

ManualsBrandsEcolink Intelligent Technology ManualsElectronicsWireless Light Sensor

SUNSET

USER MANUAL

WIRELESS SUNSET

SYNCHRONIZATION

Quick, easy installation with no wires required. SunSet

is the first wireless light sensor that automatically synchronizes your

entire landscape lighting system with the sun. On/off times are intelligently synchronized without the unreliable performance of

photocells or timers, so the lights run when you need them.

INSTALLATION OVERVIEW

1. Make sure to use the RED striped wires on Zone Control

2. Take the SunSet

over to the Zone Control receiver.

3. Learn the SunSet

into the Zone Control.

4. Place the SunSet

where it will be able to detect sunlight.

5. Test the unit to make sure it operates correctly at the desired location.

LEARNING THE SUNSET INTO A ZONE CONTROL

1. Put Zone Control Receiver in Learn Mode - Using a magnet, swipe the Zone Control REED #1. The

Zone Control will start to click; it will receive a communication from the SunSet

, stop clicking, and

turn the lights on. The two devices are mated.

2. Put SunSet

in Test Mode – When looking at the front of SunSet

(the arrow forward), place the

magnet on the left side about half way up to put SunSet

into Test Mode.

You should see a RED TEST MODE LIGHT, remove the magnet, and the red light will begin to flash.

It will be in test mode for the less than 5 seconds, and then automatically exit test mode.

3. Once complete, place the SunSet

in the desired location.

PLACEMENT OF THE SUNSET

Place the SunSet

within 100 feet of the Zone Control and with a direct line of sight between the two for best results. The

SunSet

is capable of much longer distances but you must test each location to make sure if it is within the range based on your

install parameters.

The SunSet

should ideally be placed with a relatively clear view of the western sky, the small arrow in front represents which

way SunSet

is facing. If that installation location is not available, it will still track light and dark with slight variations. The small

arrow on the sensor case is the direction that the light sensor is orientated. More shaded locations will turn the lights on slightly

earlier, and locations in more direct sunlight will turn the lights on slightly later.

SUNSET TEST

1. Place the Sun Set in a location you want to test. If lights are already on turn them “Off” with the ZoneControl remote.

2. Put SunSet

into test mode (Step #1 of Learning the SunSet

into a Zone Control)

3. Lights should turn on - check to make sure.

4. Turn Test Mode off – Note: If you swipe the magnet again BEFORE the LED stops flashing the lights will turn off.

5. Lights should turn off - check to make sure.

6. If lights did not turn on and off repeat steps 1-5 in a location closer to the receiver unit.

Magnet

Reed #1

MUST USE

RED STRIPED

WIRES

Magnet

Summary of content (2 pages)

PAGE 1
SUNSETtm USER MANUAL WIRELESS SUNSETtm SYNCHRONIZATION Quick, easy installation with no wires required. SunSettm is the first wireless light sensor that automatically synchronizes your entire landscape lighting system with the sun. On/off times are intelligently synchronized without the unreliable performance of photocells or timers, so the lights run when you need them. INSTALLATION OVERVIEW 1. 2. 3. 4. 5.
PAGE 2
PROGRAMING TIMERS FOR USE WITH SUNSET EXAMPLE SCENARIOS: Ex. #1 Want the SunSettm to turn on at sunset and the lights off at sunrise – No need to set timers, just learn the SunSettm to the Zone Control Ex.