User's Manual

WST-221 Wireless Recessed Contact

Specifications

Frequency: 319.5MHz Operating Temperature: 32°-120°F (0°-49°C)

Battery: 3V lithium CR-2 Operating Humidity: 5-95% RH non condensing

Battery life: 5 years Compatible with GE/Interlogix receivers

Magnet gap: 1 inch max Supervisory signal interval: 60min (approx.)

Enrolling

To enroll the sensor, set your panel into program mode, then go to the Learn Sensors menu. Refer

to your specific alarm panel manual for details on these menus. To activate the case tamper

simply slide the cover up and down, you will hear a click when the case latches are engaging and

disengaging. Continue until the panel responds to the sensor. Then select the appropriate sensor

group and number.

Mounting

The recessed sensor and magnet are designed to fit snuggly in a ¾ inch hole and a small flange on

the outer rim ensures the case cannot be pushed too far into a hole.

Choose a suitable location for the sensor, drill a ¾ inch by 2.5 inch hole in the door for the sensor.

Mark the location for the magnet in the frame directly in line with the sensor and drill a ¾ inch by

½ inch hole for the magnet.

Installing /Replacing the Battery

When the battery is low a signal will be sent to the control panel. To install/replace the battery:

1. Remove the cap on the transmitter.

2. Take note of how the circuit board fits into groves on the side of the case.

3. Carefully slide out the circuit board.

4. Inspect the battery holder to determine which side the battery is inserted/removed.

5. Install /replace with a CR-2 battery ensuring the + side of the battery faces towards the

circuit board.

6. Re-insert the circuit board so that the board slides within groves in the plastics.

7. Once in, replace the cap.

Note: Removing the cover will trigger a zone tamper signal to the control panel

PAGE 1
WST-221 Wireless Recessed Contact Specifications Frequency: 319.5MHz Battery: 3V lithium CR-2 Battery life: 5 years Magnet gap: 1 inch max Operating Temperature: 32°-120°F (0°-49°C) Operating Humidity: 5-95% RH non condensing Compatible with GE/Interlogix receivers Supervisory signal interval: 60min (approx.) Enrolling To enroll the sensor, set your panel into program mode, then go to the Learn Sensors menu. Refer to your specific alarm panel manual for details on these menus.
PAGE 2
FCC Compliance Statement This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device complies with part 15 of the FCC Rules.