User's Manual

WST-400 Wireless Tilt Sensor

Specifications

Frequency: 433.92MHz Operating Temperature: -22° to 120°F (-30°to 49°C)

Battery: One 3Vdc lithium CR123A (1550 mAh) Operating Humidity: 5-95% RH non condensing

Battery life: 5-8 years Compatible with DSC 433 MHz receivers

Tilt Sensor Supervisory signal interval: 60 min (approx.)

Enrolling

Each product has a label with a unique 6 digit serial number. You will need this serial number to

add this contact to your security system. Refer to your specific control panel or wireless receiver

installation instructions for details on adding a new contact.

Tilt Sensitivity

The tilt sensor will activate when the device is approximately at a 45 degree angle. By moving the

actual ball sensor up or down you can adjust this angle by a few degrees.

Note that this device has a delay of approximately 1 second to eliminate false alarms cause by

wind and vibration commonly subjected to a large garage door.

Mounting

Included with this device are mounting screws and double sided tape. For reliable bonding with

the tape ensure the surface is clean and dry. Apply the tape to the sensor and then to the desired

location. Apply firm pressure for several seconds. It is not recommended to mount the tape at

temperatures below 50°F, although after 24 hours the bond will hold at low temperatures.

Replacing the Battery

When the battery is low a signal will be sent to the control panel. To replace the battery:

1. Remove the screw securing the top cover, then remove the top cover to reveal the battery.

2. Replace with a CR123A battery ensuring the + side of the battery faces as indicated on the

device.

3. Re-attached the cover and replace the screw to secure the cover.

PAGE 1
WST-400 Wireless Tilt Sensor Specifications Frequency: 433.92MHz Battery: One 3Vdc lithium CR123A (1550 mAh) Battery life: 5-8 years Tilt Sensor Operating Temperature: -22° to 120°F (-30°to 49°C) Operating Humidity: 5-95% RH non condensing Compatible with DSC 433 MHz receivers Supervisory signal interval: 60 min (approx.) Enrolling Each product has a label with a unique 6 digit serial number. You will need this serial number to add this contact to your security system.
PAGE 2
FCC Compliance Statement This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.